Clone Disk |
Cloning a disk creates and identical copy of the source disk. However, the destination disk does not need to be the same size as the original. Macrium Reflect takes care of any system configuration parameters which means that the cloned disk can be used to replace the original disk without any further configuration or alteration being required.
To run, select the link 'Clone this disk...' under the disk you wish to clone in the 'Create a Backup' tab.
The Clone dialog shows the source disk for the cloning operation. At this point it is possible to select or de-select partitions to be cloned.
Other actions that can be performed are
Action |
Description |
Select a different source disk |
Use this option to select a different disk to be cloned |
Select a disk to clone to... |
This option will list all other suitable disks attached to the current system. Select the one you wish to be written to |
Select a different target disk |
Use this to select a different target disk |
Copy selected partitions |
Copies the selected partitions from the source disk onto the target disk |
Undo |
Undoes any changes that have been made. |
Delete Existing partition |
Deletes an existing partition on the target disk |
Displays the properties of the currently selected target partition. You can adjust the size of target partitions as required |
Note: that changes are only committed once the wizard reaches the end of the configuration stage |
Next: |